Submersible Pump | Tsurumi LH8110
Бэлэн байхгүй
Tsurumi LH Series Submersible Pumps are manufactured to keep up with developments of civil engineering and architectural technologies are increasing the necessity of digging deeper into the earth. This requires a submersible pump with a rugged construction that can withstand the high pressure so deep in the water.
ø Discharge bore mm - 100, 150, 200
Pumping Fluid - Temperature - 0-40°C
Type of Fluid - Spring water, Rain water, Ground water, Sand carrying water
PumpComponents - ImpellerClosed type impeller
Shaft Seal - Double mechanical seal
Bearings - Shielded ball bearings
Material - ImpellerChromium iron casting
Casing - Ductile iron casting EN-GJS-450-10, Grey iron casting EN-GJL-200
Shaft Sea - lSilicon carbide in oil bath
Motor - Type, Poles - Induction motor, 2 poles, IP68
Lubrication - Turbine oil (ISO VG32)
Motor Protector (built-in) - Circle thermal cut-out, Miniature protector
Insulation - Insulation class B, Insulation class F
Phase / Voltage3-phase / 400V / 50Hz / d.o.l., 3-phase / 400V / 50Hz / s.d.
Material - CasingGrey iron casting EN-GJL-200
Tsurumi's LH Series handles medium to high flows at higher heads, yet its top discharge flow-through design welcomes low water level operation for extended periods. Complete with a high chromium semi-open impeller and adjustable wear rings, our LH pumps provide you with increased wear resistance whether your application is effluent transfer, construction site drainage, or commercial/industrial dewatering.
- Discharge sizes from 4-8 inches and horsepower range from 20-150 hp
- Replaceable and adjustable high chrome wear rings provide increased wear resistance.
- Built in thermal and amperage protectors prevent motor failure in run-dry or surge conditions.
- High pressure dual silicon carbide mechanical seals operate in a separate oil chamber and are capable of withstanding operating depths of 328 feet.
- Seal pressure relief ports provide a flow path above the pump casing and allow water release from the pump and away from the shaft. This protects the mechanical seals from excessive pumping pressure or water hammer in high head pumping applications.
- Anti-wicking cable entrance and Tsurumi's exclusive oil lifter for added protection.
Төстэй бүтээгдэхүүн
